NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

To insert a module:

1. Before turning on your computer, hold the modules with the label side up and plastic side down.

2. Slide the module into the media bay. The module will click into place and the release latch will secure the module in the bay.

To remove a module:

1. To remove the module or to swap with another module make sure the unit is turned off, locate the Module Release latch on the bottom of the notebook (to the left of the bay).

2. Slide the Module Release latch to the left. This will release the module.

3. Slide the current module out of the media bay.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.