NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

Performing a Recovery without Format of Windows XP:

1. Insert the restore CD disk 1 into the CD-ROM drive.
2. Push the power button down and hold it down until the system powers off.
3. Turn the computer on, and immediately begin pressing the F2 key approximately twice a second until you see "Entering Setup" appear in the lower left of your screen. .
4. Use the Right Arrow key to move to the Boot settings page.
5. Use the Down Arrow key to highlight CD-Rom Drive, and then press the F6 key until CD-Rom Drive is at the top pf the list.
6. Press the F10 key, to save the changes and exit, Yes should already be highlighted, and then press the Enter key, and the computer will restart.
7. "Press 'R' to start recovery" will appear on the screen and you should press the R key within three seconds.
8. Press R again when you see, "Press 'R' for Standard System Recovery options".
9. You will see a Starting System Recovery screen, and then the WinBook Emergency Recovery CD Screen will then appear.
10. In the System Recovery window click the Next button at the bottom.
11. A window will appear asking if you still want to continue with the System Recovery. Click the Yes button.
12. The System Recovery will begin.
13. At approximately the half way point, you will see a message to insert the second CD, do so and System Recovery will continue.
14. When the System Recovery has completed, a window will appear telling you to click on the Restart button. Remove the restore CD and click the Restart button and the computer will restart into Windows.

To do a Format and Recovery of Windows XP:

1. Do steps 1 to 7 above.
2. Press the F key you see "Press 'F' to format drive and perform a full system recovery".
3. "Please confirm with 'Y' to format drive and install a new operating system" will appear on the screen, press Y to continue.
4. You will now see a "Preparing System Recovery partition - please wait" screen. Let that load.
5. The WinBook Emergency Recovery CD Screen will then appear and the recovery process will start.
6. At approximately the half way point, you will see a message to insert the second CD, do so and System Recovery will continue.
7. When the System Recovery is finished a window will appear telling you to click on the Restart button. Remove the restore CD and click the Restart button and the computer will restart into Windows Setup.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.