NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

To convert a volume to NTFS from the command prompt:

1. Open Command Prompt by clicking Start, point to All Programs, point to Accessories, and then click Command Prompt.
2. In the command prompt window, type
convert drive_letter: /fs:NTFS
For example, typing convert D: /fs:ntfs would format drive D: with the NTFS format.

Note: You can convert FAT or FAT32 volumes to NTFS with this command.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.