WinBook Tech Article
For more information visit www.winbookcorp.com
Subject: Problems with the system rebooting when coming out of Suspend using the Suspend functions on the XL with Windows 95
Keywords: standby hibernate power management ACPI ACP
Tech Article Number: WBTA17100299

NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.


When Norton Anti-virus is installed on the XL, and the user uses the Suspend function, when it is almost back on to the Windows Desktop, it will reboot the system again. We will need to edit the Autoexec.bat file.

  1. Click on the "Start" button.
  2. Click on "Run".
  3. Type "SYSEDIT".
  4. In the "AUTOEXEC.BAT" file you will see one or more lines that reference Norton Anti-Virus. An example is, "@C:\PROGRA~1\NORTON~1\NAVBOOT.EXE /STARTUP".

  5. Place the cursor at the beginning of this line and left click once.
  6. Type "REM" and then press the "Space Bar" once.
  7. You must do this with all lines that refer to Norton Anti-Virus.
  8. Once this is done click on the "X" to close out the System Editor.
  9. It will prompt you to save the file. Click on "Yes" to save the file.
  10. Shut down and restart the system for the changes to take effect.

Using the "REM" is called a remark. We remarked the file so that it will not operate. You must restart the unit to allow for the changes to be effective. Once that is done, the unit shouldn’t restart after a Suspend function has been used.

Note: This will cause some functions of Norton Anti-Virus to stop working. This will affect MS-DOS more than Windows. If you need to work around this to allow these items of the program to function, you must contact Symantec for a possible work around or not use the suspend features of the XL.


Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.

©2007 IPSG. All rights reserved. PowerSpec and WinBook are registered trademarks of Micro Electronics, Inc. Policies