NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

1. Make sure the computer is on, and you are in Windows.
2. Place the disk with your Irda drivers in the floppy drive.
3. From the Start menu, choose Run.
4. Type in A:\SETUP.
5. The Add Infrared Device Wizard window will appear.
6. Click on the Next button to continue.
7. Make sure Built-in Infrared port on laptop or desktop is highlighted. Then Click on the Next button.
8. Choose Generic IR Serial Port (COM3), and then click the Next button.
9. Click the Next button again.
10. Click Finish.
11. From the Start menu, choose Shutdown. Then select Restart, and then click OK, or Yes.
12. Your IR port is now configured for use. You may use the Infrared icon in Control Panel to make adjustments to your settings.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.