NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

The New Media Bus Toaster SCSI II PCMCIA card should come with the following:

• Bus Toaster PCMCIA Card
• SCSI install diskette - DO NOT USE WITH WINDOWS 95
• SCSI PCMCIA to SCSI II adapter
• Cable for PCMCIA card to SCSI connector
• Registration card
• Quick start sheet
• SCSI II User's manual

To install the Bus Toaster in Windows 95 in your WinBook XP5PRO do the following:

1. Boot up the computer into Windows 95 normally.
2. Insert the Bus Toaster card into the PCMCIA slot.
3. Windows will prompt you that it has Found New Hardware. If not, make sure the PCMCIA card is all the way in the slot.
4. Windows will then install the proper drivers.
5. Your system will begin copying files.
6. If your volume is up, you should hear two positive tones. This indicates that the Bus Toaster card has been successfully detected.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.