NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

1. Make sure your installation disk says Version 2.10. If it does not, Please contact Technical Support.
2. Insert the installation floppy first then insert the PCMCIA card.
3. Windows will inform you that new hardware was detected and launch the installation wizard.
4. Windows will show you a message that says it will complete the installation of the Ambicom Inc-AMB8002. Just click next to continue.
5. Windows will copy some files from the A: drive. If you have not set up a network on this computer, Windows will prompt you to set up your network properties, Click OK and type the correct information in the three fields, then click OK. Contact your network administrator for help with your network settings.
6. Your Ambicom card is set up now.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.