NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

This WinBook Tech Article provides information to correct the error "resuming system in progress" at bootup on the WinBook SX/DX.

1. Locate your PAUSE/BREAK key
2. Turn your computer on and as soon as you see the first flicker on the screen, start pressing the PAUSE/BREAK key until the computer starts beeping.
3. Press CTRL+ALT+S to get into the BIOS.
4. Go over to Defaults and press the Enter key.
5. Go to Exit and Save settings and press the Enter key to exit.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.