NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

Warning: Please make sure that there are no external devices, including port replicator, attached to the unit. Running battery calibration with other devices attached could result in inaccurate battery readings.

1. With the battery in the unit, plug in the A/C power and let the battery fully charge. The battery charging light will change from amber to green once the battery is fully charged.
2. Go to the CMOS setup program by tapping the Del key immediately after booting the unit at rate of about twice per second.
3. Go to the power management section of the CMOS setup program.
4. In the power management section, select Battery Auto Calibration and press PgDn.
5. Leave the unit plugged in to the A/C power. The calibration utility will drain the battery and the unit will power off by itself. Let the battery fully charge. The battery will charge faster if the unit in not turned on. This process may take up to 10 hours to complete.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.