NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

Removing the old bezel:

1. Turn the unit over, with the front of the unit facing you.
2. Locate the two bayonet tabs that hold the bottom of the bezel in place.
3. Push a fingernail into the joint between bezel and the body of the unit and slide your finger outward across the tab to the right, with your fingernail in the joint, to release this side.
4. Repeat the procedure on the left side to free that tab.
5. Slide your fingertips down between the unit and the bezel on both sides. The center of the bezel will bow in the center.
6. Pry outward approximately ½ inch and then pull upward to free the bezel.

Installing the new bezel:

1. The unit should still be upside down to install the new bezel
2. Set the left side of the bezel in place so the tab is inserted.
3. Bow the center of the bezel enough for the right side of the bezel to be placed in position.
4. Flex the top center of the bezel upward approximately ¼ inch to slide this tab into place.
5. Flex the edge downward approximately ¼ inch on left side to slide this bayonet tab into place.
6. Repeat the procedure on the right side to put that tab in place.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.