NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

Removing the Hard Drive:

1. Shut the computer off and disconnect the AC adapter. Disconnect any peripheral devices connected to the computer.
2. Remove the battery from the bottom of the unit. Refer to Battery Removal technote WBTA00200078.
3. Turn the computer so that the bottom is facing up and the ports on the back are facing away from you and the CD-Rom and the floppy drives are in front of you.
4. Directly under the floppy drive there is a panel with 2 screws in it. It is just to the right of the battery. Remove those 2 screws from the plastic and remove the panel.
   
   
   
5. Underneath is the hard drive. At the very front of the hard drive there is a rail that is bent outwards.
6. Put your finger in there are slide the hard drive towards you. You will see that the hard drive has been removed from the connector in the back.
   
   
   
7. Remove the hard drive from the computer by pulling straight up.

Installing the new Hard Drive:

1. Remove the hard drive from all of the packaging.
2. Line the posts up on the hard drive to the cut outs on the computer.
3. Place the hard drive straight down into the hard drive compartment.
4. Then, push the hard drive onto the connector into the back of the compartment.
5. Place the cover back over the hard drive.
6. Screw the screws back into the computer.
   

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.