NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

1. First make sure that the computer is shut down.  Unplug the ac power and remove the battery.  Also, remove any other peripherals attached to the computer.
2. Turn the unit over so that the front of the computer is facing you. The hard drive compartment will be located in the bottom right hand corner, to the right of the battery.
   
   
   
   
3. The hard drive compartment cover is held in place by 3 small Phillips screws. Remove the screws and then pull the cover toward the front of the computer.  It will slide off and you will see the hard drive.
4. On the hard drive there is a piece of nylon plastic.  Pull that toward the front of the computer and the hard drive will come out of its socket.



5. Reinsert the hard drive.Push it toward the back of the computer until it is securely connected again. 
6. Replace the cover and the screws.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.