WinBook Tech Article
For more information visit www.winbookcorp.com
Subject: How to Remove the Battery on the WinBook J4
Keywords: J4 battery removal and insert install
Tech Article Number: WBTA00200823

NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.


1. Power the computer off and turn the unit upside down.
2. With the front of the unit facing you there will be a pull tab to the right of the ram compartment. Simply lift the tab and the back edge of the battery (the side closest to the tab) will lift up.
3. Pull the battery out.
4. To put the battery back in, put the edge of the battery that is closest to the front of the unit first.
5. Push battery down till it locks in.


Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.

©2007 IPSG. All rights reserved. PowerSpec and WinBook are registered trademarks of Micro Electronics, Inc. Policies