NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

1. Turn off the computer and disconnect the AC adapter. Remove the main battery.

2. Turn the unit over so the front of the unit is facing you. The hard drive will be located on the front of the unit all the way to the left.

3. Remove the retaining screw that holds the hard drive in place. 
   
   

4. Slide the hard disk drive unit out of the system.
   
   

5. Slide the hard drive back into the bay and press it gently into place. If the drive does not slide in easily, slide it out slightly and try again. Do not force the drive into place. This can bend the pins on the hard drive

6. Secure the hard drive back into place with its screw.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.