NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

1. Shutdown the computer and remove all devices that are connected. Turn the notebook over so that the bottom of the computer is facing up.

2. With one hand, slide the retaining latch toward the inside of the computer and with your other hand slide the CD-ROM/DVD-ROM drive out toward the outside of the computer. (See illustration below)

3. Remove the drive all the way and then insert the new drive. The drive will slide all the way until the retaining latch slides back into place.  

4. Turn the notebook back over and plug back in your devices. At this point the drive computer is ready to be used.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.