NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

1. Turn off the computer and disconnect the AC adapter.  Remove the main battery (see Chapter 3 for instructions, if needed)..

.

2. Turn the notebook over and place it on a clear and stable surface..

.

3. Remove the screw that holds the floppy disk drive release in place (This screw also helps to secure the RAM compartment cover.) and slide the release toward the rear of the system. Slide the floppy disk drive unit until the arrow on the unit and the arrow on the system case are lined up, and then angle the unit out of its bay. Set the screw in a safe place. (Figure 6.6).



4. Angle the floppy disk drive unit into its bay so that the arrow on the unit lines up with the arrow on the system case. Slide the unit into place..

5. Slide the release back into place and secure it with its screw..

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.