NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

1. Remove the battery and the AC adapter from the WinBook. This is a must. Turn the Unit upside down and make sure the floppy drive is facing to the right and is closest to you. You will need a small #1 Phillips screwdriver.
2. First remove the small Phillips screw locking the floppy drive locking tab (See picture below). Slide the tab away from the floppy drive and while holding it in this position slide the floppy drive out and away from the WinBook.
3. Place the floppy drive in the anti-static bag of the new floppy drive.  Lay the new floppy drive back into it's cavity and slide it firmly to the left until it clicks into place and the retaining latch locks it into place.  Replace the latch retaining screw. At this point the replacement is done and the unit is ready to have the battery reinserted and the ac power connected if desired.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.