NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

General Information: This behavior is likely to have been caused by the computer being set for CRT Only in the system BIOS. In order to change the WinBook XL display type bios setting from CRT only back to LCD follow the instructions below. The easiest way to do this is to connect an external monitor to the machine so you can see what you are doing. If you do not have an external monitor available, these steps will set it back to display on the LCD panel. Please be aware that you must follow these steps exactly. You will not be able to see what you are changing without an external monitor, but follow these instructions. Any deviation from the steps could change settings needed for the system to operate.

1. Start with the computer turned off.
2. Turn the machine on and begin to tap the delete key for at least thirty seconds.
3. Press the down arrow key once.
4. Press the enter key once.
5. Press the page up key once. This will set the display to LCD only.
6. Press the esc. Key once.
7. Press the F10 key once.
8. Press the enter key once.
9. The computer will restart at this point. If the display does not come on please contact WinBook Technical Support.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.