NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

To set up your WinBook LM Port Replicator on you WinBook LM, please follow these instructions

1. With the WinBook LM turned off, verify there are no devices attached to the back of the WinBook LM, and make sure your floppy disk drive is in the unit, not the CD-ROM. Place the unit in the port replicator. At this time the latching handle is the up position. Press the WinBook LM firmly into the dock so the ports of each are firmly connected. While holding the WinBook in this position press the handle down. At this time please do not plug any peripherals into the Port Replicator.
2. Power the computer up.
3. When the computer enters Windows 95, it will begin a Hardware Detection process. Let the hardware detection processes complete and it will notify you of the successful configuration of "Dock 1"
4. Click on "OK"
5. Now you will be completely booted into windows and at you desktop

Setting up Display Properties

1. After the new configuration has been created your display settings need to be setup to display at 800x600
2. We will need your "Windows 95 Drivers for WinBook LM; Audio ESS 1688; Video NeoMagic 128 5.2
3. Insert this diskette into your Floppy disk drive and click on Start, choose Settings, and then click on Control Panel.
4. In the control panel double click on the Display icon.
5. Click on the Settings tab, then click on the Advanced Properties button.
6. In the Advanced Display Properties choose the Monitor tab and click the change button.
7. In the Select Device window click on OK.
8. Now choose Apply, then choose OK.
9. Now move the Desktop Area slider to the right until it says 800 by 600 pixels
10. Click Apply then answer yes to restart your computer
11. After the computer is done restarting, you will be back at your desktop with the correct display settings.

FAQ

Q. After installing my Port Replicator, I can no longer print. What could be wrong?

A. Check to make sure that your printers are not set to "Work Offline" This is done by clicking on Start, then settings and choose printers. Right click on the printer you are attempting to print to and verify that "Work Offline" is Unchecked. If this was checked please uncheck it and try printing again.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.