NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

Materials Needed:

• WinBook LM
• Floppy Drive Cable
• WinBook LM Floppy Drive

1. With the WinBook LM turned off.
2. Plug the cable into the parallel port on the WinBook LM.
3. Plug in the other end to the port on the back of the floppy drive.
4. Turn on the WinBook LM.

Note: The Floppy Drive, attached to the WinBook LM via the external floppy drive cable is designed to be used in the same manner as it would be if used internally.

Note: This drive attachment will work with any printer port mode (Normal, Bi-directional, EPP, and ECP).

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.