NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

The WinBook FX will arrive with the CD-ROM Drive installed in the Media Bay. To use floppy disks, you must remove the CD-ROM Drive and install the Floppy Disk Drive module. You can swap modules under the following conditions: The WinBook FX is OFF, not charging the battery, and unplugged, or is OFF and charging the battery.

For further information and illustration, please refer to the User's Manual page 1-11.

1. Make sure the power is OFF.
2. Place the WinBook FX on a flat surface, top down.
3. Locate the Media Bay release catch. Slide the release catch as shown in the illustration, and pull the module out of the bay.



4. Align the replacement module and slide it in gently until the release catch snaps into place. Be sure to push the module all the way in so it is securely seated and flush with the edge of the computer.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.