NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

Installation from a DOS prompt:

1. Insert the diskette in drive a: and type a:\install and then press Enter.
2. Answer yes to all questions.
3. Remove the diskette.

Installation from Windows File Manager:

1. Insert the diskette into the a: drive.
2. Double click on the File Manager icon (usually in the Main group).
3. Click on the A drive button.
4. Double click on the file Install.Exe
5. Answer yes to all questions.
6. Remove the diskette.

Enable 32-Bit Disk Access:

1. Double click on the Control Panel icon. (usually in the Main group)
2. Double click on 386 Enhanced.
3. Click on Virtual Memory.
4. Click on Change.
5. At the bottom of the window, you will see a check box titled Use 32-Bit Disk Access. When this box is checked 32-Bit Disk Access is enabled. Click in this box to check it.
6. Click on OK to save your changes.
7. Restart Windows, so the change takes effect.

Only one 32-bit Disk Access Driver for IDE drives can be active at a time. The Install program can recognize some of them, and will replace them. If a conflict occurs, you may need to edit your System.ini file. To remove the Enhanced 32-Bit Disk Access Driver run Install /r on the command line.

The Enhanced 32-Bit Disk Access driver is compatible with Windows for Workgroups V3.11 32-Bit File Access with the following exceptions: 32-Bit File Access and 32-Bit Disk Access (FASTDISK) cannot BOTH be enabled if a hard disk drive and an IDE CD-ROM drive are both attached to the primary controller (AS WITH THE WINBOOK FX). You may use EITHER 32-Bit Disk Access OR 32-Bit File Access. This problem does not occur with non-IDE CD-ROMS or IDE CD-ROMS attached to a secondary controller. (The Windows 32-Bit Disk Access driver will not work when there is an IDE CD-ROM on the primary controller.) If you must choose between 32-Bit File Access and 32-Bit Disk Access, Ontrack recommends that you choose 32-Bit File Access.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.