NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

Your WinBook has one Express Card slot. The Express Card technology takes advantage of the scalable, high-bandwidth serial PCI Express and USB 2.0 interfaces.

The following instruction provides you with a basic installation and removal instructions for the Express Card. For more information, please refer to the manual of your Express Card.

Inserting an Express Card

1. Locate the Express Card slot on the side of the notebook. If there is the dummy card in the slot, remove it first.

2. Insert the Express Card into the slot (usually with its label facing up) and push it until it is firmly seated.

Removing an Express Card

1. Press the end of the Express Card to partially eject the card.

2. Pull the Express Card out of the slot.

3. Insert the dummy card back to the slot.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.