NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

Follow the directions below to remove and/or install a battery into the WinBook W500 series notebook computer.

To remove the battery pack, follow these steps:

1. Turn OFF the computer. Disconnect the AC cord remove the battery and disconnect all cables/devices attached to the notebook.
2. Slide the battery latch to the unlocked position and hold it in place. (Figure 1 item 1)
3. Rotate the battery pack out of the computer. (Figure 1 item 2)

Figure 1

To install the battery pack:

1. Align the front edge of the battery pack with the front of the opening in the computer. Rotate the battery into the down position as shown in Figure 2.
2. The battery latch is spring loaded and will automatically secure the battery in place.

Figure 2

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.