NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

This article demonstrates how to install/upgrade the memory in the WinBook W200 series notebook computers.

1. Turn OFF the computer. Disconnect the AC cord remove the battery and disconnect all cables/devices attached to the notebook.
2. Carefully turn the notebook over and lay it on a flat surface.
3. Locate and remove the seven (7) screws from the system device compartment cover. (Figure 1)

Figure 1

4. Remove the cover.
5. If the removal of existing memory is required, press out on the latches located on both edges of the socket at the same time. The memory should pop up at an angle. (Figure 2)

Figure 2

6. Install the new memory module into the memory socket. It will only fit in one direction. Insert the module at an angle of approximately 30 degrees into the empty memory socket. (Figure 3)

Figure 3

7. Press downward on the memory until it lays flat. There should be an audible click as the latches of the slot connector secure the memory into place.
8. Replace the system device compartment cover and secure it with the seven (7) screws.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.