NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

1. Remove the battery pack.
2. Remove the two screws fastening the RAM compartment cover.
3. Lift the cover off and place it to the side.

4. The RAM slots are now exposed. If replacing an existing module, gently push out on the edge clips to release the module, then angle the card slightly upwards and out from the slot.

5. To install a new memory module, align the module with its pins towards the edge connector of the slot. In order to help you orient the module, the edge connector has been made with two unequal-length sections. You will only be able to insert the module in one direction.
6. Holding the module at a shallow angle, insert the module into the slot. When the module is fully seated, the pins should not be visible.
7. Press downward on the module until it lays flat. You should hear an audible click as the latches of the slot connector secure the module in place.
8. Replace the RAM compartment cover and secure it with the two screws.
9. Replace the battery pack.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.