NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

1. Ensure that the battery is fully charged before beginning.
   
2. Disconnect all peripherals from the computer (EG. Printers, PMCCIA cards, External keyboards/mice)
   
3. Turn on the computer and tap the F2 key to enter the bios.
   
4. Once in the bios use your arrow keys to move over to the BOOT section.
   
5. Make sure that CD-ROM/DVD drive is at the top of the list and place your Restore CD in the unit.
   Save and exit the bios.
   
6. Once the computer starts to reboot start tapping the F8 key to get the Windows 98 Startup Menu.
   
7. Choose Safe Mode Command Prompt Only and hit Enter. It will put you at a Command Prompt (A:>).
   
8. Remove the Restore CD and let the computer sit here till it shuts itself off.
   
9. After the computer shuts itself off. Plug in your AC power to recharge the system.

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.