NOTE: You, the customer, are solely responsible for data security. WinBook strongly recommends that you perform a backup of all personal data contained on your system prior to performing this procedure. Warning: WinBook will NOT be held responsible for any data loss incurred during this process.

1. Boot the computer to the Windows Desktop.
2. Insert the Ambicom Ethernet Card into the PCMCIA slot on the side of your WinBook Computer.
3. The PCMCIA Card Installation Wizard will appear. Insert the driver disk provided with your Ambicom card into your floppy disk drive. Click Next.
4. The option to let Windows search for the best driver should be checked. Click Next.
5. The option to search the Floppy or A:\ drive should be checked. Click Next.
6. A:\AMBICOM8110.INF  should be highlighted. Click Next.
7. Windows will now be ready to install the selected driver for the device. Click Finish.
8. When prompted to restart your computer remove the disk from the floppy drive and click OK to restart. 
9. The Ambicom card should now be set up properly. You will now need to configure your network settings. 

Your feedback is greatly appreciated. If you have noticed any problems with this tech article, or if you feel that something is not clear enough, please E-mail our Technical Support department by clicking on the link below. Please include the Technical Article Number and the specific area that you feel is inaccurate. Thank you. 
WinBook Tech Article Feedback

Disclaimer: This information is being provided to you as a service from the Technical Support Department of WinBook Computers. It is intended to assist you in the resolution of your technical problems or questions. If you feel uncomfortable implementing any of the information or suggestions contained herein then you should e-mail the WinBook Technical Support Department. WinBook will not be held responsible for any loss of information, data or programming as a result of the use of this TechNote.